Lock Type H Programming Instructions

How to Change the Code on Your Safe

Default Code for New Safes: 1-2-3-4 followed by #

Important:
Before starting, make sure you already have your new code ready.
You will only have 8 seconds to complete Steps 1–4.

---

Steps to Program a New Code:

1. Enter the current code followed by #.

   • ✅ Green light = Code accepted

2. Press *.

   •  Yellow light turns on (learn mode activated)

3. Enter new code ( 1 to 8) digits.
   

4. Press * Again, to confirm the new code.
   

   • Yellow light turns off + 3 beeps = Code changed successfully

---

Next Step:

• Test the new code with the door open to make sure it was programmed correctly.
  

• Related Articles

• QAS-1845 - Alternate Programming

  If you are having difficulties programing your Stack-On QAS-1845 it may be a different version, please watch the video below for the step by step: We hope that this information was useful and your issue was resolved. If not, please contact our ...

• Unresponsive keypad (no sounds, no lights) or partial function

  The keypad is the gateway to communicate from the outside of the safe to the lock located inside the door. Let's review one topic at a time. Unresponsive Keypad If the safe is not operated often, it might be forgotten that it uses a battery that ...